homeguardptm@gmail.com

(02) 9809 6501

April 6, 2022
Comments Off

What to Expect From a Building and Pest Inspection in Melbourne

Post by :

Category: Blog


Pre Purchase Building and Pest Inspections – How much does it cost? And what should you look for? Listed below are the most common problems a building and pest inspection in Melbourne will discover. Termites, timber pests, water leaks, and mold are just a few examples of what you might find. But don’t worry, you’re not alone. There are plenty of other problems you should be aware of too.

Cost of building and pest inspection in Melbourne

The cost of a building and pest inspection in Melbourne depends on the size and type of property. For example, a small house may cost $399, while a large house might run from $500 to $650. You may be surprised to learn that a pre-purchase building inspection can be expensive if you’re not serious about purchasing a home yet. If you’re unsure of your budget, a general guideline is to budget $500 for a building and pest inspection in Melbourne.

Termites

During a termite inspection, a technician will check for signs of dampness, plumbing leaks, and signs of a termite infestation. Termite inspections should also check for signs of termite infestation, including areas of dryness and the structure of the roof. The inspector will also check for signs of water damage, such as overflowing pipes and inadequate drainage. A termite inspection report will show you the areas of your property that are most vulnerable to infestation.

Timber pests

Timber pests are an important part of a building and pest inspection Melbourne. They can cause significant damage to a building and can be difficult to detect, but an inspection of the entire structure will help to prevent further issues down the track. In addition to identifying termites and borers, the inspector will check for wood rots, fungal decay, and water leaks and dampness. In addition to their destructive effects, these pests are not uncommon in Melbourne, and even buildings constructed of brick veneer or concrete are susceptible to infestations.

Water leaks

The inspector from Melbourne House Check recently discovered a water leak during a routine building and pest inspection. The source of the leak was the bathtub waste. Unsealed showers leak water through the floor and walls, causing a significant amount of rot and water damage. This can go unnoticed for years. If the leak is not caught quickly, it can lead to significant costs and inconvenience.

Thermal imaging camera

Termite Solutions uses a thermal imaging camera in addition to binoculars, a torch, and a tapping tool during building and pest inspections. This technology helps detect even the tiniest differences in temperature caused by termites. The FLIR thermal imaging camera is an important tool for detecting low-level termite infestations, and it is used by pest inspectors as a valuable diagnostic tool.

Pre-purchase building and pest inspection

If you are looking to buy a new house, you might have some questions. While you may think it’s okay to buy a home without a pest inspection, it’s not. Pests are difficult to detect and can damage the structure of a residence. Fortunately, pre-purchase building and pest inspections can help you avoid costly mistakes and hassles.

Looking for building and pest inspection Melbourne? Call Building Property Inspections Melbourne today for building inspections Croydon.

Comments are closed